[Feature]add MT2731_MP2_MR2_SVN388 baseline version

Change-Id: Ief04314834b31e27effab435d3ca8ba33b499059
diff --git a/src/kernel/linux/v4.14/drivers/mtd/maps/ixp4xx.c b/src/kernel/linux/v4.14/drivers/mtd/maps/ixp4xx.c
new file mode 100644
index 0000000..e3180d5
--- /dev/null
+++ b/src/kernel/linux/v4.14/drivers/mtd/maps/ixp4xx.c
@@ -0,0 +1,261 @@
+/*
+ * drivers/mtd/maps/ixp4xx.c
+ *
+ * MTD Map file for IXP4XX based systems. Please do not make per-board
+ * changes in here. If your board needs special setup, do it in your
+ * platform level code in arch/arm/mach-ixp4xx/board-setup.c
+ *
+ * Original Author: Intel Corporation
+ * Maintainer: Deepak Saxena <dsaxena@mvista.com>
+ *
+ * Copyright (C) 2002 Intel Corporation
+ * Copyright (C) 2003-2004 MontaVista Software, Inc.
+ *
+ */
+
+#include <linux/err.h>
+#include <linux/module.h>
+#include <linux/types.h>
+#include <linux/kernel.h>
+#include <linux/string.h>
+#include <linux/slab.h>
+#include <linux/ioport.h>
+#include <linux/device.h>
+#include <linux/platform_device.h>
+
+#include <linux/mtd/mtd.h>
+#include <linux/mtd/map.h>
+#include <linux/mtd/partitions.h>
+
+#include <asm/io.h>
+#include <asm/mach/flash.h>
+
+#include <linux/reboot.h>
+
+/*
+ * Read/write a 16 bit word from flash address 'addr'.
+ *
+ * When the cpu is in little-endian mode it swizzles the address lines
+ * ('address coherency') so we need to undo the swizzling to ensure commands
+ * and the like end up on the correct flash address.
+ *
+ * To further complicate matters, due to the way the expansion bus controller
+ * handles 32 bit reads, the byte stream ABCD is stored on the flash as:
+ *     D15    D0
+ *     +---+---+
+ *     | A | B | 0
+ *     +---+---+
+ *     | C | D | 2
+ *     +---+---+
+ * This means that on LE systems each 16 bit word must be swapped. Note that
+ * this requires CONFIG_MTD_CFI_BE_BYTE_SWAP to be enabled to 'unswap' the CFI
+ * data and other flash commands which are always in D7-D0.
+ */
+#ifndef __ARMEB__
+#ifndef CONFIG_MTD_CFI_BE_BYTE_SWAP
+#  error CONFIG_MTD_CFI_BE_BYTE_SWAP required
+#endif
+
+static inline u16 flash_read16(void __iomem *addr)
+{
+	return be16_to_cpu(__raw_readw((void __iomem *)((unsigned long)addr ^ 0x2)));
+}
+
+static inline void flash_write16(u16 d, void __iomem *addr)
+{
+	__raw_writew(cpu_to_be16(d), (void __iomem *)((unsigned long)addr ^ 0x2));
+}
+
+#define	BYTE0(h)	((h) & 0xFF)
+#define	BYTE1(h)	(((h) >> 8) & 0xFF)
+
+#else
+
+static inline u16 flash_read16(const void __iomem *addr)
+{
+	return __raw_readw(addr);
+}
+
+static inline void flash_write16(u16 d, void __iomem *addr)
+{
+	__raw_writew(d, addr);
+}
+
+#define	BYTE0(h)	(((h) >> 8) & 0xFF)
+#define	BYTE1(h)	((h) & 0xFF)
+#endif
+
+static map_word ixp4xx_read16(struct map_info *map, unsigned long ofs)
+{
+	map_word val;
+	val.x[0] = flash_read16(map->virt + ofs);
+	return val;
+}
+
+/*
+ * The IXP4xx expansion bus only allows 16-bit wide acceses
+ * when attached to a 16-bit wide device (such as the 28F128J3A),
+ * so we can't just memcpy_fromio().
+ */
+static void ixp4xx_copy_from(struct map_info *map, void *to,
+			     unsigned long from, ssize_t len)
+{
+	u8 *dest = (u8 *) to;
+	void __iomem *src = map->virt + from;
+
+	if (len <= 0)
+		return;
+
+	if (from & 1) {
+		*dest++ = BYTE1(flash_read16(src-1));
+		src++;
+		--len;
+	}
+
+	while (len >= 2) {
+		u16 data = flash_read16(src);
+		*dest++ = BYTE0(data);
+		*dest++ = BYTE1(data);
+		src += 2;
+		len -= 2;
+	}
+
+	if (len > 0)
+		*dest++ = BYTE0(flash_read16(src));
+}
+
+/*
+ * Unaligned writes are ignored, causing the 8-bit
+ * probe to fail and proceed to the 16-bit probe (which succeeds).
+ */
+static void ixp4xx_probe_write16(struct map_info *map, map_word d, unsigned long adr)
+{
+	if (!(adr & 1))
+		flash_write16(d.x[0], map->virt + adr);
+}
+
+/*
+ * Fast write16 function without the probing check above
+ */
+static void ixp4xx_write16(struct map_info *map, map_word d, unsigned long adr)
+{
+	flash_write16(d.x[0], map->virt + adr);
+}
+
+struct ixp4xx_flash_info {
+	struct mtd_info *mtd;
+	struct map_info map;
+	struct resource *res;
+};
+
+static const char * const probes[] = { "RedBoot", "cmdlinepart", NULL };
+
+static int ixp4xx_flash_remove(struct platform_device *dev)
+{
+	struct flash_platform_data *plat = dev_get_platdata(&dev->dev);
+	struct ixp4xx_flash_info *info = platform_get_drvdata(dev);
+
+	if(!info)
+		return 0;
+
+	if (info->mtd) {
+		mtd_device_unregister(info->mtd);
+		map_destroy(info->mtd);
+	}
+
+	if (plat->exit)
+		plat->exit();
+
+	return 0;
+}
+
+static int ixp4xx_flash_probe(struct platform_device *dev)
+{
+	struct flash_platform_data *plat = dev_get_platdata(&dev->dev);
+	struct ixp4xx_flash_info *info;
+	struct mtd_part_parser_data ppdata = {
+		.origin = dev->resource->start,
+	};
+	int err = -1;
+
+	if (!plat)
+		return -ENODEV;
+
+	if (plat->init) {
+		err = plat->init();
+		if (err)
+			return err;
+	}
+
+	info = devm_kzalloc(&dev->dev, sizeof(struct ixp4xx_flash_info),
+			    GFP_KERNEL);
+	if(!info) {
+		err = -ENOMEM;
+		goto Error;
+	}
+
+	platform_set_drvdata(dev, info);
+
+	/*
+	 * Tell the MTD layer we're not 1:1 mapped so that it does
+	 * not attempt to do a direct access on us.
+	 */
+	info->map.phys = NO_XIP;
+	info->map.size = resource_size(dev->resource);
+
+	/*
+	 * We only support 16-bit accesses for now. If and when
+	 * any board use 8-bit access, we'll fixup the driver to
+	 * handle that.
+	 */
+	info->map.bankwidth = 2;
+	info->map.name = dev_name(&dev->dev);
+	info->map.read = ixp4xx_read16;
+	info->map.write = ixp4xx_probe_write16;
+	info->map.copy_from = ixp4xx_copy_from;
+
+	info->map.virt = devm_ioremap_resource(&dev->dev, dev->resource);
+	if (IS_ERR(info->map.virt)) {
+		err = PTR_ERR(info->map.virt);
+		goto Error;
+	}
+
+	info->mtd = do_map_probe(plat->map_name, &info->map);
+	if (!info->mtd) {
+		printk(KERN_ERR "IXP4XXFlash: map_probe failed\n");
+		err = -ENXIO;
+		goto Error;
+	}
+	info->mtd->dev.parent = &dev->dev;
+
+	/* Use the fast version */
+	info->map.write = ixp4xx_write16;
+
+	err = mtd_device_parse_register(info->mtd, probes, &ppdata,
+			plat->parts, plat->nr_parts);
+	if (err) {
+		printk(KERN_ERR "Could not parse partitions\n");
+		goto Error;
+	}
+
+	return 0;
+
+Error:
+	ixp4xx_flash_remove(dev);
+	return err;
+}
+
+static struct platform_driver ixp4xx_flash_driver = {
+	.probe		= ixp4xx_flash_probe,
+	.remove		= ixp4xx_flash_remove,
+	.driver		= {
+		.name	= "IXP4XX-Flash",
+	},
+};
+
+module_platform_driver(ixp4xx_flash_driver);
+
+MODULE_LICENSE("GPL");
+MODULE_DESCRIPTION("MTD map driver for Intel IXP4xx systems");
+MODULE_AUTHOR("Deepak Saxena");
+MODULE_ALIAS("platform:IXP4XX-Flash");