| // SPDX-License-Identifier: GPL-2.0-or-later OR MIT |
| |
| #include "ar7240.dtsi" |
| |
| #include <dt-bindings/gpio/gpio.h> |
| #include <dt-bindings/input/input.h> |
| |
| / { |
| aliases { |
| led-boot = &led_system; |
| led-failsafe = &led_system; |
| led-running = &led_system; |
| led-upgrade = &led_system; |
| label-mac-device = &ath9k; |
| }; |
| |
| keys { |
| compatible = "gpio-keys"; |
| |
| reset { |
| label = "reset"; |
| linux,code = <KEY_RESTART>; |
| gpios = <&gpio 11 GPIO_ACTIVE_LOW>; |
| debounce-interval = <60>; |
| }; |
| |
| wps { |
| label = "wps"; |
| linux,code = <KEY_WPS_BUTTON>; |
| gpios = <&gpio 12 GPIO_ACTIVE_LOW>; |
| debounce-interval = <60>; |
| }; |
| }; |
| |
| leds: leds { |
| compatible = "gpio-leds"; |
| |
| pinctrl-names = "default"; |
| pinctrl-0 = <&pinmux_switch_led_pins>; |
| |
| led_system: system { |
| label = "green:system"; |
| gpios = <&gpio 1 GPIO_ACTIVE_LOW>; |
| }; |
| |
| qss { |
| label = "green:qss"; |
| gpios = <&gpio 0 GPIO_ACTIVE_LOW>; |
| }; |
| }; |
| |
| ath9k-leds { |
| compatible = "gpio-leds"; |
| |
| wlan { |
| label = "green:wlan"; |
| gpios = <&ath9k 1 GPIO_ACTIVE_LOW>; |
| linux,default-trigger = "phy0tpt"; |
| }; |
| }; |
| }; |
| |
| &spi { |
| status = "okay"; |
| |
| flash@0 { |
| compatible = "jedec,spi-nor"; |
| reg = <0>; |
| spi-max-frequency = <25000000>; |
| |
| partitions { |
| compatible = "fixed-partitions"; |
| #address-cells = <1>; |
| #size-cells = <1>; |
| |
| uboot: partition@0 { |
| reg = <0x0 0x20000>; |
| label = "u-boot"; |
| read-only; |
| }; |
| |
| partition@20000 { |
| compatible = "tplink,firmware"; |
| reg = <0x20000 0x3d0000>; |
| label = "firmware"; |
| }; |
| |
| art: partition@3f0000 { |
| reg = <0x3f0000 0x10000>; |
| label = "art"; |
| read-only; |
| }; |
| }; |
| }; |
| }; |
| |
| ð1 { |
| status = "okay"; |
| }; |
| |
| &pcie { |
| status = "okay"; |
| |
| ath9k: wifi@0,0 { |
| reg = <0x0000 0 0 0 0>; |
| qca,no-eeprom; |
| mtd-mac-address = <&uboot 0x1fc00>; |
| #gpio-cells = <2>; |
| gpio-controller; |
| }; |
| }; |
| |
| &pinmux { |
| pinmux_switch_led_pins: switch_led_pins { |
| pinctrl-single,bits = <0x0 0x0 0xf8>; |
| }; |
| }; |