| echo "CuBox OpenWrt Boot script" |
| |
| # Set console variable for both UART and HDMI |
| setenv console console=ttymxc0,115200 video=mxcfb0:dev=hdmi,1920x1080M@60,if=RGB24,bpp=32 |
| |
| # Find correct dtb |
| if test ${board_rev} = MX6DL; then |
| setenv fdt_soc_type imx6dl; |
| elif test ${board_rev} = MX6Q; then |
| setenv fdt_soc_type imx6q; |
| fi |
| if test ${board_name} = CUBOXI; then |
| setenv fdt_name ${fdt_soc_type}-cubox-i.dtb; |
| elif test ${board_name} = HUMMINGBOARD; then |
| setenv fdt_name ${fdt_soc_type}-hummingboard.dtb; |
| fi |
| |
| # Set correct devtype and partition |
| if test ${devtype} != mmc; then setenv devtype mmc; fi |
| if mmc dev 0; then |
| setenv mmcdev 0 |
| elif mmc dev 1; then |
| setenv mmcdev 1 |
| fi |
| |
| # Boot from the SD card is supported at the moment |
| setenv bootargs "${console} root=/dev/mmcblk1p2 rw rootwait" |
| mmc dev ${mmcdev} |
| load ${devtype} ${mmcdev}:${devplist} ${kernel_addr_r} /uImage |
| load ${devtype} ${mmcdev}:${devplist} ${fdt_addr_r} /${fdt_name} |
| bootz ${kernel_addr_r} - ${fdt_addr_r} |