ASR_BASE
Change-Id: Icf3719cc0afe3eeb3edc7fa80a2eb5199ca9dda1
diff --git a/marvell/linux/arch/arm/boot/dts/imx7d.dtsi b/marvell/linux/arch/arm/boot/dts/imx7d.dtsi
new file mode 100644
index 0000000..2b9d0b1
--- /dev/null
+++ b/marvell/linux/arch/arm/boot/dts/imx7d.dtsi
@@ -0,0 +1,213 @@
+// SPDX-License-Identifier: GPL-2.0+ OR MIT
+//
+// Copyright 2015 Freescale Semiconductor, Inc.
+// Copyright 2016 Toradex AG
+
+#include "imx7s.dtsi"
+#include <dt-bindings/reset/imx7-reset.h>
+
+/ {
+ aliases {
+ usb0 = &usbotg1;
+ usb1 = &usbotg2;
+ usb2 = &usbh;
+ };
+
+ cpus {
+ cpu0: cpu@0 {
+ clock-frequency = <996000000>;
+ operating-points-v2 = <&cpu0_opp_table>;
+ #cooling-cells = <2>;
+ nvmem-cells = <&cpu_speed_grade>;
+ nvmem-cell-names = "speed_grade";
+ };
+
+ cpu1: cpu@1 {
+ compatible = "arm,cortex-a7";
+ device_type = "cpu";
+ reg = <1>;
+ clock-frequency = <996000000>;
+ operating-points-v2 = <&cpu0_opp_table>;
+ cpu-idle-states = <&cpu_sleep_wait>;
+ };
+ };
+
+ timer {
+ compatible = "arm,armv7-timer";
+ interrupt-parent = <&intc>;
+ interrupts = <GIC_PPI 13 (GIC_CPU_MASK_SIMPLE(2) | IRQ_TYPE_LEVEL_LOW)>,
+ <GIC_PPI 14 (GIC_CPU_MASK_SIMPLE(2) | IRQ_TYPE_LEVEL_LOW)>,
+ <GIC_PPI 11 (GIC_CPU_MASK_SIMPLE(2) | IRQ_TYPE_LEVEL_LOW)>,
+ <GIC_PPI 10 (GIC_CPU_MASK_SIMPLE(2) | IRQ_TYPE_LEVEL_LOW)>;
+ };
+
+ cpu0_opp_table: opp-table {
+ compatible = "operating-points-v2";
+ opp-shared;
+
+ opp-792000000 {
+ opp-hz = /bits/ 64 <792000000>;
+ opp-microvolt = <1000000>;
+ clock-latency-ns = <150000>;
+ opp-supported-hw = <0xf>, <0xf>;
+ };
+
+ opp-996000000 {
+ opp-hz = /bits/ 64 <996000000>;
+ opp-microvolt = <1100000>;
+ clock-latency-ns = <150000>;
+ opp-supported-hw = <0xc>, <0xf>;
+ };
+
+ opp-1200000000 {
+ opp-hz = /bits/ 64 <1200000000>;
+ opp-microvolt = <1225000>;
+ clock-latency-ns = <150000>;
+ opp-supported-hw = <0x8>, <0xf>;
+ };
+ };
+
+ usbphynop2: usbphynop2 {
+ compatible = "usb-nop-xceiv";
+ clocks = <&clks IMX7D_USB_PHY2_CLK>;
+ clock-names = "main_clk";
+ #phy-cells = <0>;
+ };
+
+ soc {
+ etm@3007d000 {
+ compatible = "arm,coresight-etm3x", "arm,primecell";
+ reg = <0x3007d000 0x1000>;
+
+ /*
+ * System will hang if added nosmp in kernel command line
+ * without arm,primecell-periphid because amba bus try to
+ * read id and core1 power off at this time.
+ */
+ arm,primecell-periphid = <0xbb956>;
+ cpu = <&cpu1>;
+ clocks = <&clks IMX7D_MAIN_AXI_ROOT_CLK>;
+ clock-names = "apb_pclk";
+
+ out-ports {
+ port {
+ etm1_out_port: endpoint {
+ remote-endpoint = <&ca_funnel_in_port1>;
+ };
+ };
+ };
+ };
+
+ intc: interrupt-controller@31001000 {
+ compatible = "arm,cortex-a7-gic";
+ interrupts = <GIC_PPI 9 (GIC_CPU_MASK_SIMPLE(2) | IRQ_TYPE_LEVEL_HIGH)>;
+ #interrupt-cells = <3>;
+ interrupt-controller;
+ interrupt-parent = <&intc>;
+ reg = <0x31001000 0x1000>,
+ <0x31002000 0x2000>,
+ <0x31004000 0x2000>,
+ <0x31006000 0x2000>;
+ };
+ };
+};
+
+&aips2 {
+ pcie_phy: pcie-phy@306d0000 {
+ compatible = "fsl,imx7d-pcie-phy";
+ reg = <0x306d0000 0x10000>;
+ status = "disabled";
+ };
+};
+
+&aips3 {
+ usbotg2: usb@30b20000 {
+ compatible = "fsl,imx7d-usb", "fsl,imx27-usb";
+ reg = <0x30b20000 0x200>;
+ interrupts = <GIC_SPI 42 IRQ_TYPE_LEVEL_HIGH>;
+ clocks = <&clks IMX7D_USB_CTRL_CLK>;
+ fsl,usbphy = <&usbphynop2>;
+ fsl,usbmisc = <&usbmisc2 0>;
+ phy-clkgate-delay-us = <400>;
+ status = "disabled";
+ };
+
+ usbmisc2: usbmisc@30b20200 {
+ #index-cells = <1>;
+ compatible = "fsl,imx7d-usbmisc", "fsl,imx6q-usbmisc";
+ reg = <0x30b20200 0x200>;
+ };
+
+ fec2: ethernet@30bf0000 {
+ compatible = "fsl,imx7d-fec", "fsl,imx6sx-fec";
+ reg = <0x30bf0000 0x10000>;
+ interrupt-names = "int0", "int1", "int2", "pps";
+ interrupts = <GIC_SPI 102 IRQ_TYPE_LEVEL_HIGH>,
+ <GIC_SPI 100 IRQ_TYPE_LEVEL_HIGH>,
+ <GIC_SPI 101 IRQ_TYPE_LEVEL_HIGH>,
+ <GIC_SPI 103 IRQ_TYPE_LEVEL_HIGH>;
+ clocks = <&clks IMX7D_ENET2_IPG_ROOT_CLK>,
+ <&clks IMX7D_ENET_AXI_ROOT_CLK>,
+ <&clks IMX7D_ENET2_TIME_ROOT_CLK>,
+ <&clks IMX7D_PLL_ENET_MAIN_125M_CLK>,
+ <&clks IMX7D_ENET_PHY_REF_ROOT_CLK>;
+ clock-names = "ipg", "ahb", "ptp",
+ "enet_clk_ref", "enet_out";
+ fsl,num-tx-queues = <3>;
+ fsl,num-rx-queues = <3>;
+ status = "disabled";
+ };
+
+ pcie: pcie@33800000 {
+ compatible = "fsl,imx7d-pcie", "snps,dw-pcie";
+ reg = <0x33800000 0x4000>,
+ <0x4ff00000 0x80000>;
+ reg-names = "dbi", "config";
+ #address-cells = <3>;
+ #size-cells = <2>;
+ device_type = "pci";
+ bus-range = <0x00 0xff>;
+ ranges = <0x81000000 0 0 0x4ff80000 0 0x00010000 /* downstream I/O */
+ 0x82000000 0 0x40000000 0x40000000 0 0x0ff00000>; /* non-prefetchable memory */
+ num-lanes = <1>;
+ num-viewport = <4>;
+ interrupts = <GIC_SPI 122 IRQ_TYPE_LEVEL_HIGH>;
+ interrupt-names = "msi";
+ #interrupt-cells = <1>;
+ interrupt-map-mask = <0 0 0 0x7>;
+ /*
+ * Reference manual lists pci irqs incorrectly
+ * Real hardware ordering is same as imx6: D+MSI, C, B, A
+ */
+ interrupt-map = <0 0 0 1 &intc GIC_SPI 125 IRQ_TYPE_LEVEL_HIGH>,
+ <0 0 0 2 &intc GIC_SPI 124 IRQ_TYPE_LEVEL_HIGH>,
+ <0 0 0 3 &intc GIC_SPI 123 IRQ_TYPE_LEVEL_HIGH>,
+ <0 0 0 4 &intc GIC_SPI 122 IRQ_TYPE_LEVEL_HIGH>;
+ clocks = <&clks IMX7D_PCIE_CTRL_ROOT_CLK>,
+ <&clks IMX7D_PLL_ENET_MAIN_100M_CLK>,
+ <&clks IMX7D_PCIE_PHY_ROOT_CLK>;
+ clock-names = "pcie", "pcie_bus", "pcie_phy";
+ assigned-clocks = <&clks IMX7D_PCIE_CTRL_ROOT_SRC>,
+ <&clks IMX7D_PCIE_PHY_ROOT_SRC>;
+ assigned-clock-parents = <&clks IMX7D_PLL_ENET_MAIN_250M_CLK>,
+ <&clks IMX7D_PLL_ENET_MAIN_100M_CLK>;
+
+ fsl,max-link-speed = <2>;
+ power-domains = <&pgc_pcie_phy>;
+ resets = <&src IMX7_RESET_PCIEPHY>,
+ <&src IMX7_RESET_PCIE_CTRL_APPS_EN>,
+ <&src IMX7_RESET_PCIE_CTRL_APPS_TURNOFF>;
+ reset-names = "pciephy", "apps", "turnoff";
+ fsl,imx7d-pcie-phy = <&pcie_phy>;
+ status = "disabled";
+ };
+};
+
+&ca_funnel_in_ports {
+ port@1 {
+ reg = <1>;
+ ca_funnel_in_port1: endpoint {
+ remote-endpoint = <&etm1_out_port>;
+ };
+ };
+};