ASR_BASE
Change-Id: Icf3719cc0afe3eeb3edc7fa80a2eb5199ca9dda1
diff --git a/marvell/linux/arch/arm/boot/dts/omap-zoom-common.dtsi b/marvell/linux/arch/arm/boot/dts/omap-zoom-common.dtsi
new file mode 100644
index 0000000..d4ad9e5
--- /dev/null
+++ b/marvell/linux/arch/arm/boot/dts/omap-zoom-common.dtsi
@@ -0,0 +1,92 @@
+// SPDX-License-Identifier: GPL-2.0
+/*
+ * Common features on the Zoom debug board
+ */
+
+#include "omap-gpmc-smsc911x.dtsi"
+
+&gpmc {
+ ranges = <3 0 0x10000000 0x1000000>, /* CS3: 16MB for UART */
+ <7 0 0x2c000000 0x01000000>;
+
+ /*
+ * Four port TL16CP754C serial port on GPMC,
+ * they probably share the same GPIO IRQ
+ * REVISIT: Add timing support from slls644g.pdf
+ */
+ uart@3,0 {
+ compatible = "ns16550a";
+ reg = <3 0 8>; /* CS3, offset 0, IO size 8 */
+ bank-width = <2>;
+ reg-shift = <1>;
+ reg-io-width = <1>;
+ interrupt-parent = <&gpio4>;
+ interrupts = <6 IRQ_TYPE_EDGE_RISING>; /* gpio102 */
+ clock-frequency = <1843200>;
+ current-speed = <115200>;
+ gpmc,mux-add-data = <0>;
+ gpmc,device-width = <1>;
+ gpmc,wait-pin = <1>;
+ gpmc,cycle2cycle-samecsen = <1>;
+ gpmc,cycle2cycle-diffcsen = <1>;
+ gpmc,cs-on-ns = <5>;
+ gpmc,cs-rd-off-ns = <155>;
+ gpmc,cs-wr-off-ns = <155>;
+ gpmc,adv-on-ns = <15>;
+ gpmc,adv-rd-off-ns = <40>;
+ gpmc,adv-wr-off-ns = <40>;
+ gpmc,oe-on-ns = <45>;
+ gpmc,oe-off-ns = <145>;
+ gpmc,we-on-ns = <45>;
+ gpmc,we-off-ns = <145>;
+ gpmc,rd-cycle-ns = <155>;
+ gpmc,wr-cycle-ns = <155>;
+ gpmc,access-ns = <145>;
+ gpmc,page-burst-access-ns = <20>;
+ gpmc,bus-turnaround-ns = <20>;
+ gpmc,cycle2cycle-delay-ns = <20>;
+ gpmc,wait-monitoring-ns = <0>;
+ gpmc,clk-activation-ns = <0>;
+ gpmc,wr-data-mux-bus-ns = <45>;
+ gpmc,wr-access-ns = <145>;
+ };
+ uart@3,1 {
+ compatible = "ns16550a";
+ reg = <3 0x100 8>; /* CS3, offset 0x100, IO size 8 */
+ bank-width = <2>;
+ reg-shift = <1>;
+ reg-io-width = <1>;
+ interrupt-parent = <&gpio4>;
+ interrupts = <6 IRQ_TYPE_EDGE_RISING>; /* gpio102 */
+ clock-frequency = <1843200>;
+ current-speed = <115200>;
+ };
+ uart@3,2 {
+ compatible = "ns16550a";
+ reg = <3 0x200 8>; /* CS3, offset 0x200, IO size 8 */
+ bank-width = <2>;
+ reg-shift = <1>;
+ reg-io-width = <1>;
+ interrupt-parent = <&gpio4>;
+ interrupts = <6 IRQ_TYPE_EDGE_RISING>; /* gpio102 */
+ clock-frequency = <1843200>;
+ current-speed = <115200>;
+ };
+ uart@3,3 {
+ compatible = "ns16550a";
+ reg = <3 0x300 8>; /* CS3, offset 0x300, IO size 8 */
+ bank-width = <2>;
+ reg-shift = <1>;
+ reg-io-width = <1>;
+ interrupt-parent = <&gpio4>;
+ interrupts = <6 IRQ_TYPE_EDGE_RISING>; /* gpio102 */
+ clock-frequency = <1843200>;
+ current-speed = <115200>;
+ };
+
+ ethernet@gpmc {
+ reg = <7 0 0xff>;
+ interrupt-parent = <&gpio5>;
+ interrupts = <30 IRQ_TYPE_LEVEL_LOW>; /* gpio158 */
+ };
+};