ASR_BASE
Change-Id: Icf3719cc0afe3eeb3edc7fa80a2eb5199ca9dda1
diff --git a/target/linux/bcm63xx/patches-5.4/404-NET-bcm63xx_enet-move-phy_-dis-connect-into-probe-re.patch b/target/linux/bcm63xx/patches-5.4/404-NET-bcm63xx_enet-move-phy_-dis-connect-into-probe-re.patch
new file mode 100644
index 0000000..c9392c2
--- /dev/null
+++ b/target/linux/bcm63xx/patches-5.4/404-NET-bcm63xx_enet-move-phy_-dis-connect-into-probe-re.patch
@@ -0,0 +1,247 @@
+From 7fa63fdde703aaabaa7199ae879219737a98a3f3 Mon Sep 17 00:00:00 2001
+From: Jonas Gorski <jonas.gorski@gmail.com>
+Date: Fri, 6 Jan 2012 12:24:18 +0100
+Subject: [PATCH] NET: bcm63xx_enet: move phy_(dis)connect into probe/remove
+
+Only connect/disconnect the phy during probe and remove, not during any
+open/close. The phy seldom changes during the runtime, and disconnecting
+the phy during close will prevent it from keeping any configuration over
+a down/up cycle.
+
+Signed-off-by: Jonas Gorski <jonas.gorski@gmail.com>
+---
+ drivers/net/ethernet/broadcom/bcm63xx_enet.c | 158 +++++++++++++--------------
+ 1 file changed, 78 insertions(+), 80 deletions(-)
+
+--- a/drivers/net/ethernet/broadcom/bcm63xx_enet.c
++++ b/drivers/net/ethernet/broadcom/bcm63xx_enet.c
+@@ -893,10 +893,8 @@ static int bcm_enet_open(struct net_devi
+ struct bcm_enet_priv *priv;
+ struct sockaddr addr;
+ struct device *kdev;
+- struct phy_device *phydev;
+ int i, ret;
+ unsigned int size;
+- char phy_id[MII_BUS_ID_SIZE + 3];
+ void *p;
+ u32 val;
+
+@@ -904,31 +902,10 @@ static int bcm_enet_open(struct net_devi
+ kdev = &priv->pdev->dev;
+
+ if (priv->has_phy) {
+- /* connect to PHY */
+- snprintf(phy_id, sizeof(phy_id), PHY_ID_FMT,
+- priv->mii_bus->id, priv->phy_id);
+-
+- phydev = phy_connect(dev, phy_id, bcm_enet_adjust_phy_link,
+- PHY_INTERFACE_MODE_MII);
+-
+- if (IS_ERR(phydev)) {
+- dev_err(kdev, "could not attach to PHY\n");
+- return PTR_ERR(phydev);
+- }
+-
+- /* mask with MAC supported features */
+- phy_support_sym_pause(phydev);
+- phy_set_max_speed(phydev, SPEED_100);
+- phy_set_sym_pause(phydev, priv->pause_rx, priv->pause_rx,
+- priv->pause_auto);
+-
+- phy_attached_info(phydev);
+-
++ /* Reset state */
+ priv->old_link = 0;
+ priv->old_duplex = -1;
+ priv->old_pause = -1;
+- } else {
+- phydev = NULL;
+ }
+
+ /* mask all interrupts and request them */
+@@ -938,7 +915,7 @@ static int bcm_enet_open(struct net_devi
+
+ ret = request_irq(dev->irq, bcm_enet_isr_mac, 0, dev->name, dev);
+ if (ret)
+- goto out_phy_disconnect;
++ return ret;
+
+ ret = request_irq(priv->irq_rx, bcm_enet_isr_dma, 0,
+ dev->name, dev);
+@@ -1100,8 +1077,8 @@ static int bcm_enet_open(struct net_devi
+ enet_dmac_writel(priv, priv->dma_chan_int_mask,
+ ENETDMAC_IRMASK, priv->tx_chan);
+
+- if (phydev)
+- phy_start(phydev);
++ if (priv->has_phy)
++ phy_start(dev->phydev);
+ else
+ bcm_enet_adjust_link(dev);
+
+@@ -1131,10 +1108,6 @@ out_freeirq_rx:
+ out_freeirq:
+ free_irq(dev->irq, dev);
+
+-out_phy_disconnect:
+- if (phydev)
+- phy_disconnect(phydev);
+-
+ return ret;
+ }
+
+@@ -1227,10 +1200,6 @@ static int bcm_enet_stop(struct net_devi
+ free_irq(priv->irq_rx, dev);
+ free_irq(dev->irq, dev);
+
+- /* release phy */
+- if (priv->has_phy)
+- phy_disconnect(dev->phydev);
+-
+ /* reset BQL after forced tx reclaim to not kernel panic */
+ netdev_reset_queue(dev);
+
+@@ -1802,14 +1771,47 @@ static int bcm_enet_probe(struct platfor
+
+ /* do minimal hardware init to be able to probe mii bus */
+ bcm_enet_hw_preinit(priv);
++ spin_lock_init(&priv->rx_lock);
++
++ /* init rx timeout (used for oom) */
++ timer_setup(&priv->rx_timeout, bcm_enet_refill_rx_timer, 0);
++
++ /* init the mib update lock&work */
++ mutex_init(&priv->mib_update_lock);
++ INIT_WORK(&priv->mib_update_task, bcm_enet_update_mib_counters_defer);
++
++ /* zero mib counters */
++ for (i = 0; i < ENET_MIB_REG_COUNT; i++)
++ enet_writel(priv, 0, ENET_MIB_REG(i));
++
++ /* register netdevice */
++ dev->netdev_ops = &bcm_enet_ops;
++ netif_napi_add(dev, &priv->napi, bcm_enet_poll, 16);
++
++ dev->ethtool_ops = &bcm_enet_ethtool_ops;
++ /* MTU range: 46 - 2028 */
++ dev->min_mtu = ETH_ZLEN - ETH_HLEN;
++ dev->max_mtu = BCMENET_MAX_MTU - VLAN_ETH_HLEN;
++ SET_NETDEV_DEV(dev, &pdev->dev);
++
++ ret = register_netdev(dev);
++ if (ret)
++ goto out_uninit_hw;
++
++ netif_carrier_off(dev);
++ platform_set_drvdata(pdev, dev);
++ priv->pdev = pdev;
++ priv->net_dev = dev;
+
+ /* MII bus registration */
+ if (priv->has_phy) {
++ struct phy_device *phydev;
++ char phy_id[MII_BUS_ID_SIZE + 3];
+
+ priv->mii_bus = mdiobus_alloc();
+ if (!priv->mii_bus) {
+ ret = -ENOMEM;
+- goto out_uninit_hw;
++ goto out_unregister_netdev;
+ }
+
+ bus = priv->mii_bus;
+@@ -1833,6 +1835,26 @@ static int bcm_enet_probe(struct platfor
+ dev_err(&pdev->dev, "unable to register mdio bus\n");
+ goto out_free_mdio;
+ }
++
++ /* connect to PHY */
++ snprintf(phy_id, sizeof(phy_id), PHY_ID_FMT,
++ priv->mii_bus->id, priv->phy_id);
++
++ phydev = phy_connect(dev, phy_id, bcm_enet_adjust_phy_link,
++ PHY_INTERFACE_MODE_MII);
++
++ if (IS_ERR(phydev)) {
++ dev_err(&pdev->dev, "could not attach to PHY\n");
++ goto out_unregister_mdio;
++ }
++
++ /* mask with MAC supported features */
++ phy_support_sym_pause(phydev);
++ phy_set_max_speed(phydev, SPEED_100);
++ phy_set_sym_pause(phydev, priv->pause_rx, priv->pause_rx,
++ priv->pause_auto);
++
++ phy_attached_info(phydev);
+ } else {
+
+ /* run platform code to initialize PHY device */
+@@ -1840,45 +1862,16 @@ static int bcm_enet_probe(struct platfor
+ pd->mii_config(dev, 1, bcm_enet_mdio_read_mii,
+ bcm_enet_mdio_write_mii)) {
+ dev_err(&pdev->dev, "unable to configure mdio bus\n");
+- goto out_uninit_hw;
++ goto out_unregister_netdev;
+ }
+ }
+
+- spin_lock_init(&priv->rx_lock);
+-
+- /* init rx timeout (used for oom) */
+- timer_setup(&priv->rx_timeout, bcm_enet_refill_rx_timer, 0);
+-
+- /* init the mib update lock&work */
+- mutex_init(&priv->mib_update_lock);
+- INIT_WORK(&priv->mib_update_task, bcm_enet_update_mib_counters_defer);
+-
+- /* zero mib counters */
+- for (i = 0; i < ENET_MIB_REG_COUNT; i++)
+- enet_writel(priv, 0, ENET_MIB_REG(i));
+-
+- /* register netdevice */
+- dev->netdev_ops = &bcm_enet_ops;
+- netif_napi_add(dev, &priv->napi, bcm_enet_poll, 16);
+-
+- dev->ethtool_ops = &bcm_enet_ethtool_ops;
+- /* MTU range: 46 - 2028 */
+- dev->min_mtu = ETH_ZLEN - ETH_HLEN;
+- dev->max_mtu = BCMENET_MAX_MTU - VLAN_ETH_HLEN;
+- SET_NETDEV_DEV(dev, &pdev->dev);
+-
+- ret = register_netdev(dev);
+- if (ret)
+- goto out_unregister_mdio;
+-
+- netif_carrier_off(dev);
+- platform_set_drvdata(pdev, dev);
+- priv->pdev = pdev;
+- priv->net_dev = dev;
+-
+ return 0;
+
+ out_unregister_mdio:
++ if (dev->phydev)
++ phy_disconnect(dev->phydev);
++
+ if (priv->mii_bus)
+ mdiobus_unregister(priv->mii_bus);
+
+@@ -1886,6 +1879,9 @@ out_free_mdio:
+ if (priv->mii_bus)
+ mdiobus_free(priv->mii_bus);
+
++out_unregister_netdev:
++ unregister_netdev(dev);
++
+ out_uninit_hw:
+ /* turn off mdc clock */
+ enet_writel(priv, 0, ENET_MIISC_REG);
+@@ -1916,6 +1912,7 @@ static int bcm_enet_remove(struct platfo
+ enet_writel(priv, 0, ENET_MIISC_REG);
+
+ if (priv->has_phy) {
++ phy_disconnect(dev->phydev);
+ mdiobus_unregister(priv->mii_bus);
+ mdiobus_free(priv->mii_bus);
+ } else {