blob: fcf5035810b5737889c8e403d5f52f7be2085f33 [file] [log] [blame]
b.liue9582032025-04-17 19:18:16 +08001Qualcomm Ethernet ETHQOS device
2
3This documents dwmmac based ethernet device which supports Gigabit
4ethernet for version v2.3.0 onwards.
5
6This device has following properties:
7
8Required properties:
9
10- compatible: Should be qcom,qcs404-ethqos"
11
12- reg: Address and length of the register set for the device
13
14- reg-names: Should contain register names "stmmaceth", "rgmii"
15
16- clocks: Should contain phandle to clocks
17
18- clock-names: Should contain clock names "stmmaceth", "pclk",
19 "ptp_ref", "rgmii"
20
21- interrupts: Should contain phandle to interrupts
22
23- interrupt-names: Should contain interrupt names "macirq", "eth_lpi"
24
25Rest of the properties are defined in stmmac.txt file in same directory
26
27
28Example:
29
30ethernet: ethernet@7a80000 {
31 compatible = "qcom,qcs404-ethqos";
32 reg = <0x07a80000 0x10000>,
33 <0x07a96000 0x100>;
34 reg-names = "stmmaceth", "rgmii";
35 clock-names = "stmmaceth", "pclk", "ptp_ref", "rgmii";
36 clocks = <&gcc GCC_ETH_AXI_CLK>,
37 <&gcc GCC_ETH_SLAVE_AHB_CLK>,
38 <&gcc GCC_ETH_PTP_CLK>,
39 <&gcc GCC_ETH_RGMII_CLK>;
40 interrupts = <GIC_SPI 56 IRQ_TYPE_LEVEL_HIGH>,
41 <GIC_SPI 55 IRQ_TYPE_LEVEL_HIGH>;
42 interrupt-names = "macirq", "eth_lpi";
43 snps,reset-gpio = <&tlmm 60 GPIO_ACTIVE_LOW>;
44 snps,reset-active-low;
45
46 snps,txpbl = <8>;
47 snps,rxpbl = <2>;
48 snps,aal;
49 snps,tso;
50
51 phy-handle = <&phy1>;
52 phy-mode = "rgmii";
53
54 mdio {
55 #address-cells = <0x1>;
56 #size-cells = <0x0>;
57 compatible = "snps,dwmac-mdio";
58 phy1: phy@4 {
59 device_type = "ethernet-phy";
60 reg = <0x4>;
61 };
62 };
63
64};