| b.liu | e958203 | 2025-04-17 19:18:16 +0800 | [diff] [blame] | 1 | // SPDX-License-Identifier: GPL-2.0-or-later OR MIT |
| 2 | |
| 3 | #include "ar7240.dtsi" |
| 4 | |
| 5 | #include <dt-bindings/gpio/gpio.h> |
| 6 | #include <dt-bindings/input/input.h> |
| 7 | |
| 8 | / { |
| 9 | aliases { |
| 10 | led-boot = &led_system; |
| 11 | led-failsafe = &led_system; |
| 12 | led-running = &led_system; |
| 13 | led-upgrade = &led_system; |
| 14 | label-mac-device = &ath9k; |
| 15 | }; |
| 16 | |
| 17 | keys { |
| 18 | compatible = "gpio-keys"; |
| 19 | |
| 20 | reset { |
| 21 | label = "reset"; |
| 22 | linux,code = <KEY_RESTART>; |
| 23 | gpios = <&gpio 11 GPIO_ACTIVE_LOW>; |
| 24 | debounce-interval = <60>; |
| 25 | }; |
| 26 | |
| 27 | wps { |
| 28 | label = "wps"; |
| 29 | linux,code = <KEY_WPS_BUTTON>; |
| 30 | gpios = <&gpio 12 GPIO_ACTIVE_LOW>; |
| 31 | debounce-interval = <60>; |
| 32 | }; |
| 33 | }; |
| 34 | |
| 35 | leds: leds { |
| 36 | compatible = "gpio-leds"; |
| 37 | |
| 38 | pinctrl-names = "default"; |
| 39 | pinctrl-0 = <&pinmux_switch_led_pins>; |
| 40 | |
| 41 | led_system: system { |
| 42 | label = "green:system"; |
| 43 | gpios = <&gpio 1 GPIO_ACTIVE_LOW>; |
| 44 | }; |
| 45 | |
| 46 | qss { |
| 47 | label = "green:qss"; |
| 48 | gpios = <&gpio 0 GPIO_ACTIVE_LOW>; |
| 49 | }; |
| 50 | }; |
| 51 | |
| 52 | ath9k-leds { |
| 53 | compatible = "gpio-leds"; |
| 54 | |
| 55 | wlan { |
| 56 | label = "green:wlan"; |
| 57 | gpios = <&ath9k 1 GPIO_ACTIVE_LOW>; |
| 58 | linux,default-trigger = "phy0tpt"; |
| 59 | }; |
| 60 | }; |
| 61 | }; |
| 62 | |
| 63 | &spi { |
| 64 | status = "okay"; |
| 65 | |
| 66 | flash@0 { |
| 67 | compatible = "jedec,spi-nor"; |
| 68 | reg = <0>; |
| 69 | spi-max-frequency = <25000000>; |
| 70 | |
| 71 | partitions { |
| 72 | compatible = "fixed-partitions"; |
| 73 | #address-cells = <1>; |
| 74 | #size-cells = <1>; |
| 75 | |
| 76 | uboot: partition@0 { |
| 77 | reg = <0x0 0x20000>; |
| 78 | label = "u-boot"; |
| 79 | read-only; |
| 80 | }; |
| 81 | |
| 82 | partition@20000 { |
| 83 | compatible = "tplink,firmware"; |
| 84 | reg = <0x20000 0x3d0000>; |
| 85 | label = "firmware"; |
| 86 | }; |
| 87 | |
| 88 | art: partition@3f0000 { |
| 89 | reg = <0x3f0000 0x10000>; |
| 90 | label = "art"; |
| 91 | read-only; |
| 92 | }; |
| 93 | }; |
| 94 | }; |
| 95 | }; |
| 96 | |
| 97 | ð1 { |
| 98 | status = "okay"; |
| 99 | }; |
| 100 | |
| 101 | &pcie { |
| 102 | status = "okay"; |
| 103 | |
| 104 | ath9k: wifi@0,0 { |
| 105 | reg = <0x0000 0 0 0 0>; |
| 106 | qca,no-eeprom; |
| 107 | mtd-mac-address = <&uboot 0x1fc00>; |
| 108 | #gpio-cells = <2>; |
| 109 | gpio-controller; |
| 110 | }; |
| 111 | }; |
| 112 | |
| 113 | &pinmux { |
| 114 | pinmux_switch_led_pins: switch_led_pins { |
| 115 | pinctrl-single,bits = <0x0 0x0 0xf8>; |
| 116 | }; |
| 117 | }; |