| # SPDX-License-Identifier: GPL-2.0 |
| # |
| # Multiplexer devices |
| # |
| |
| config MULTIPLEXER |
| tristate |
| |
| menu "Multiplexer drivers" |
| depends on MULTIPLEXER |
| |
| config MUX_ADG792A |
| tristate "Analog Devices ADG792A/ADG792G Multiplexers" |
| depends on I2C |
| help |
| ADG792A and ADG792G Wide Bandwidth Triple 4:1 Multiplexers |
| |
| The driver supports both operating the three multiplexers in |
| parallel and operating them independently. |
| |
| To compile the driver as a module, choose M here: the module will |
| be called mux-adg792a. |
| |
| config MUX_ADGS1408 |
| tristate "Analog Devices ADGS1408/ADGS1409 Multiplexers" |
| depends on SPI |
| help |
| ADGS1408 8:1 multiplexer and ADGS1409 double 4:1 multiplexer |
| switches. |
| |
| To compile the driver as a module, choose M here: the module will |
| be called mux-adgs1408. |
| |
| config MUX_GPIO |
| tristate "GPIO-controlled Multiplexer" |
| depends on GPIOLIB || COMPILE_TEST |
| help |
| GPIO-controlled Multiplexer controller. |
| |
| The driver builds a single multiplexer controller using a number |
| of gpio pins. For N pins, there will be 2^N possible multiplexer |
| states. The GPIO pins can be connected (by the hardware) to several |
| multiplexers, which in that case will be operated in parallel. |
| |
| To compile the driver as a module, choose M here: the module will |
| be called mux-gpio. |
| |
| config MUX_MMIO |
| tristate "MMIO register bitfield-controlled Multiplexer" |
| depends on (OF && MFD_SYSCON) || COMPILE_TEST |
| help |
| MMIO register bitfield-controlled Multiplexer controller. |
| |
| The driver builds multiplexer controllers for bitfields in a syscon |
| register. For N bit wide bitfields, there will be 2^N possible |
| multiplexer states. |
| |
| To compile the driver as a module, choose M here: the module will |
| be called mux-mmio. |
| |
| endmenu |