|  | /* | 
|  | *  74Hx164 - Generic serial-in/parallel-out 8-bits shift register GPIO driver | 
|  | * | 
|  | *  Copyright (C) 2010 Gabor Juhos <juhosg@openwrt.org> | 
|  | *  Copyright (C) 2010 Miguel Gaio <miguel.gaio@efixo.com> | 
|  | * | 
|  | *  This program is free software; you can redistribute it and/or modify | 
|  | *  it under the terms of the GNU General Public License version 2 as | 
|  | *  published by the Free Software Foundation. | 
|  | */ | 
|  |  | 
|  | #include <linux/init.h> | 
|  | #include <linux/mutex.h> | 
|  | #include <linux/spi/spi.h> | 
|  | #include <linux/gpio/driver.h> | 
|  | #include <linux/gpio/consumer.h> | 
|  | #include <linux/slab.h> | 
|  | #include <linux/module.h> | 
|  |  | 
|  | #define GEN_74X164_NUMBER_GPIOS	8 | 
|  |  | 
|  | struct gen_74x164_chip { | 
|  | struct gpio_chip	gpio_chip; | 
|  | struct mutex		lock; | 
|  | struct gpio_desc	*gpiod_oe; | 
|  | u32			registers; | 
|  | /* | 
|  | * Since the registers are chained, every byte sent will make | 
|  | * the previous byte shift to the next register in the | 
|  | * chain. Thus, the first byte sent will end up in the last | 
|  | * register at the end of the transfer. So, to have a logical | 
|  | * numbering, store the bytes in reverse order. | 
|  | */ | 
|  | u8			buffer[]; | 
|  | }; | 
|  |  | 
|  | static int __gen_74x164_write_config(struct gen_74x164_chip *chip) | 
|  | { | 
|  | return spi_write(to_spi_device(chip->gpio_chip.parent), chip->buffer, | 
|  | chip->registers); | 
|  | } | 
|  |  | 
|  | static int gen_74x164_get_value(struct gpio_chip *gc, unsigned offset) | 
|  | { | 
|  | struct gen_74x164_chip *chip = gpiochip_get_data(gc); | 
|  | u8 bank = chip->registers - 1 - offset / 8; | 
|  | u8 pin = offset % 8; | 
|  | int ret; | 
|  |  | 
|  | mutex_lock(&chip->lock); | 
|  | ret = (chip->buffer[bank] >> pin) & 0x1; | 
|  | mutex_unlock(&chip->lock); | 
|  |  | 
|  | return ret; | 
|  | } | 
|  |  | 
|  | static void gen_74x164_set_value(struct gpio_chip *gc, | 
|  | unsigned offset, int val) | 
|  | { | 
|  | struct gen_74x164_chip *chip = gpiochip_get_data(gc); | 
|  | u8 bank = chip->registers - 1 - offset / 8; | 
|  | u8 pin = offset % 8; | 
|  |  | 
|  | mutex_lock(&chip->lock); | 
|  | if (val) | 
|  | chip->buffer[bank] |= (1 << pin); | 
|  | else | 
|  | chip->buffer[bank] &= ~(1 << pin); | 
|  |  | 
|  | __gen_74x164_write_config(chip); | 
|  | mutex_unlock(&chip->lock); | 
|  | } | 
|  |  | 
|  | static void gen_74x164_set_multiple(struct gpio_chip *gc, unsigned long *mask, | 
|  | unsigned long *bits) | 
|  | { | 
|  | struct gen_74x164_chip *chip = gpiochip_get_data(gc); | 
|  | unsigned int i, idx, shift; | 
|  | u8 bank, bankmask; | 
|  |  | 
|  | mutex_lock(&chip->lock); | 
|  | for (i = 0, bank = chip->registers - 1; i < chip->registers; | 
|  | i++, bank--) { | 
|  | idx = i / sizeof(*mask); | 
|  | shift = i % sizeof(*mask) * BITS_PER_BYTE; | 
|  | bankmask = mask[idx] >> shift; | 
|  | if (!bankmask) | 
|  | continue; | 
|  |  | 
|  | chip->buffer[bank] &= ~bankmask; | 
|  | chip->buffer[bank] |= bankmask & (bits[idx] >> shift); | 
|  | } | 
|  | __gen_74x164_write_config(chip); | 
|  | mutex_unlock(&chip->lock); | 
|  | } | 
|  |  | 
|  | static int gen_74x164_direction_output(struct gpio_chip *gc, | 
|  | unsigned offset, int val) | 
|  | { | 
|  | gen_74x164_set_value(gc, offset, val); | 
|  | return 0; | 
|  | } | 
|  |  | 
|  | static int gen_74x164_probe(struct spi_device *spi) | 
|  | { | 
|  | struct gen_74x164_chip *chip; | 
|  | u32 nregs; | 
|  | int ret; | 
|  |  | 
|  | /* | 
|  | * bits_per_word cannot be configured in platform data | 
|  | */ | 
|  | spi->bits_per_word = 8; | 
|  |  | 
|  | ret = spi_setup(spi); | 
|  | if (ret < 0) | 
|  | return ret; | 
|  |  | 
|  | if (of_property_read_u32(spi->dev.of_node, "registers-number", | 
|  | &nregs)) { | 
|  | dev_err(&spi->dev, | 
|  | "Missing registers-number property in the DT.\n"); | 
|  | return -EINVAL; | 
|  | } | 
|  |  | 
|  | chip = devm_kzalloc(&spi->dev, sizeof(*chip) + nregs, GFP_KERNEL); | 
|  | if (!chip) | 
|  | return -ENOMEM; | 
|  |  | 
|  | chip->gpiod_oe = devm_gpiod_get_optional(&spi->dev, "enable", | 
|  | GPIOD_OUT_LOW); | 
|  | if (IS_ERR(chip->gpiod_oe)) | 
|  | return PTR_ERR(chip->gpiod_oe); | 
|  |  | 
|  | gpiod_set_value_cansleep(chip->gpiod_oe, 1); | 
|  |  | 
|  | spi_set_drvdata(spi, chip); | 
|  |  | 
|  | chip->gpio_chip.label = spi->modalias; | 
|  | chip->gpio_chip.direction_output = gen_74x164_direction_output; | 
|  | chip->gpio_chip.get = gen_74x164_get_value; | 
|  | chip->gpio_chip.set = gen_74x164_set_value; | 
|  | chip->gpio_chip.set_multiple = gen_74x164_set_multiple; | 
|  | chip->gpio_chip.base = -1; | 
|  |  | 
|  | chip->registers = nregs; | 
|  | chip->gpio_chip.ngpio = GEN_74X164_NUMBER_GPIOS * chip->registers; | 
|  |  | 
|  | chip->gpio_chip.can_sleep = true; | 
|  | chip->gpio_chip.parent = &spi->dev; | 
|  | chip->gpio_chip.owner = THIS_MODULE; | 
|  |  | 
|  | mutex_init(&chip->lock); | 
|  |  | 
|  | ret = __gen_74x164_write_config(chip); | 
|  | if (ret) { | 
|  | dev_err(&spi->dev, "Failed writing: %d\n", ret); | 
|  | goto exit_destroy; | 
|  | } | 
|  |  | 
|  | ret = gpiochip_add_data(&chip->gpio_chip, chip); | 
|  | if (!ret) | 
|  | return 0; | 
|  |  | 
|  | exit_destroy: | 
|  | mutex_destroy(&chip->lock); | 
|  |  | 
|  | return ret; | 
|  | } | 
|  |  | 
|  | static int gen_74x164_remove(struct spi_device *spi) | 
|  | { | 
|  | struct gen_74x164_chip *chip = spi_get_drvdata(spi); | 
|  |  | 
|  | gpiod_set_value_cansleep(chip->gpiod_oe, 0); | 
|  | gpiochip_remove(&chip->gpio_chip); | 
|  | mutex_destroy(&chip->lock); | 
|  |  | 
|  | return 0; | 
|  | } | 
|  |  | 
|  | static const struct of_device_id gen_74x164_dt_ids[] = { | 
|  | { .compatible = "fairchild,74hc595" }, | 
|  | { .compatible = "nxp,74lvc594" }, | 
|  | {}, | 
|  | }; | 
|  | MODULE_DEVICE_TABLE(of, gen_74x164_dt_ids); | 
|  |  | 
|  | static struct spi_driver gen_74x164_driver = { | 
|  | .driver = { | 
|  | .name		= "74x164", | 
|  | .of_match_table	= gen_74x164_dt_ids, | 
|  | }, | 
|  | .probe		= gen_74x164_probe, | 
|  | .remove		= gen_74x164_remove, | 
|  | }; | 
|  | module_spi_driver(gen_74x164_driver); | 
|  |  | 
|  | MODULE_AUTHOR("Gabor Juhos <juhosg@openwrt.org>"); | 
|  | MODULE_AUTHOR("Miguel Gaio <miguel.gaio@efixo.com>"); | 
|  | MODULE_DESCRIPTION("GPIO expander driver for 74X164 8-bits shift register"); | 
|  | MODULE_LICENSE("GPL v2"); |