| xj | b04a402 | 2021-11-25 15:01:52 +0800 | [diff] [blame] | 1 | # SPDX-License-Identifier: GPL-2.0 |
| 2 | # |
| 3 | # Makefile for the Linux kernel device drivers. |
| 4 | # |
| 5 | # 15 Sep 2000, Christoph Hellwig <hch@infradead.org> |
| 6 | # Rewritten to use lists instead of if-statements. |
| 7 | # |
| rjw | 3d6a50e | 2023-02-20 13:35:42 +0800 | [diff] [blame] | 8 | #Lxf add in 2022/12/2 for gpio init |
| 9 | obj-y += lynq_gpio_init/ |
| 10 | #Lxf add in 2022/12/2 for gpio init end |
| xj | b04a402 | 2021-11-25 15:01:52 +0800 | [diff] [blame] | 11 | obj-y += irqchip/ |
| 12 | obj-y += bus/ |
| 13 | |
| 14 | obj-$(CONFIG_GENERIC_PHY) += phy/ |
| 15 | |
| 16 | # GPIO must come after pinctrl as gpios may need to mux pins etc |
| 17 | obj-$(CONFIG_PINCTRL) += pinctrl/ |
| 18 | obj-$(CONFIG_GPIOLIB) += gpio/ |
| 19 | obj-y += pwm/ |
| 20 | |
| 21 | obj-y += pci/ |
| 22 | |
| 23 | obj-$(CONFIG_PARISC) += parisc/ |
| 24 | obj-$(CONFIG_RAPIDIO) += rapidio/ |
| 25 | obj-y += video/ |
| 26 | obj-y += idle/ |
| 27 | |
| 28 | # IPMI must come before ACPI in order to provide IPMI opregion support |
| 29 | obj-y += char/ipmi/ |
| 30 | |
| 31 | obj-$(CONFIG_ACPI) += acpi/ |
| 32 | obj-$(CONFIG_SFI) += sfi/ |
| 33 | # PnP must come after ACPI since it will eventually need to check if acpi |
| 34 | # was used and do nothing if so |
| 35 | obj-$(CONFIG_PNP) += pnp/ |
| 36 | obj-y += amba/ |
| 37 | |
| 38 | obj-y += clk/ |
| 39 | # Many drivers will want to use DMA so this has to be made available |
| 40 | # really early. |
| 41 | obj-$(CONFIG_DMADEVICES) += dma/ |
| 42 | |
| 43 | # SOC specific infrastructure drivers. |
| 44 | obj-y += soc/ |
| 45 | |
| 46 | obj-$(CONFIG_VIRTIO) += virtio/ |
| 47 | obj-$(CONFIG_XEN) += xen/ |
| 48 | |
| 49 | # regulators early, since some subsystems rely on them to initialize |
| 50 | obj-$(CONFIG_REGULATOR) += regulator/ |
| 51 | |
| 52 | # reset controllers early, since gpu drivers might rely on them to initialize |
| 53 | obj-$(CONFIG_RESET_CONTROLLER) += reset/ |
| 54 | |
| 55 | # tty/ comes before char/ so that the VT console is the boot-time |
| 56 | # default. |
| 57 | obj-y += tty/ |
| 58 | obj-y += char/ |
| 59 | |
| 60 | # iommu/ comes before gpu as gpu are using iommu controllers |
| 61 | obj-$(CONFIG_IOMMU_SUPPORT) += iommu/ |
| 62 | |
| 63 | # gpu/ comes after char for AGP vs DRM startup and after iommu |
| 64 | obj-y += gpu/ |
| 65 | |
| 66 | obj-$(CONFIG_CONNECTOR) += connector/ |
| 67 | |
| 68 | # i810fb and intelfb depend on char/agp/ |
| 69 | obj-$(CONFIG_FB_I810) += video/fbdev/i810/ |
| 70 | obj-$(CONFIG_FB_INTEL) += video/fbdev/intelfb/ |
| 71 | |
| 72 | obj-$(CONFIG_PARPORT) += parport/ |
| 73 | obj-$(CONFIG_NVM) += lightnvm/ |
| 74 | obj-$(CONFIG_MEMORY) += memory/ |
| 75 | obj-y += base/ block/ misc/ mfd/ nfc/ |
| 76 | obj-$(CONFIG_LIBNVDIMM) += nvdimm/ |
| 77 | obj-$(CONFIG_DAX) += dax/ |
| 78 | obj-$(CONFIG_DMA_SHARED_BUFFER) += dma-buf/ |
| 79 | obj-$(CONFIG_NUBUS) += nubus/ |
| 80 | obj-y += macintosh/ |
| 81 | obj-$(CONFIG_IDE) += ide/ |
| 82 | obj-y += scsi/ |
| 83 | obj-y += nvme/ |
| 84 | obj-$(CONFIG_ATA) += ata/ |
| 85 | obj-$(CONFIG_TARGET_CORE) += target/ |
| 86 | obj-$(CONFIG_MTD) += mtd/ |
| 87 | obj-$(CONFIG_SPI) += spi/ |
| 88 | obj-$(CONFIG_SPMI) += spmi/ |
| 89 | obj-$(CONFIG_HSI) += hsi/ |
| 90 | obj-$(CONFIG_SLIMBUS) += slimbus/ |
| 91 | obj-y += net/ |
| 92 | obj-$(CONFIG_ATM) += atm/ |
| 93 | obj-$(CONFIG_FUSION) += message/ |
| 94 | obj-y += firewire/ |
| 95 | obj-$(CONFIG_UIO) += uio/ |
| 96 | obj-$(CONFIG_VFIO) += vfio/ |
| 97 | obj-y += cdrom/ |
| 98 | obj-y += auxdisplay/ |
| 99 | obj-$(CONFIG_PCCARD) += pcmcia/ |
| 100 | obj-$(CONFIG_DIO) += dio/ |
| 101 | obj-$(CONFIG_SBUS) += sbus/ |
| 102 | obj-$(CONFIG_ZORRO) += zorro/ |
| 103 | obj-$(CONFIG_ATA_OVER_ETH) += block/aoe/ |
| 104 | obj-$(CONFIG_PARIDE) += block/paride/ |
| 105 | obj-$(CONFIG_TC) += tc/ |
| 106 | obj-$(CONFIG_UWB) += uwb/ |
| 107 | obj-$(CONFIG_USB_PHY) += usb/ |
| 108 | obj-$(CONFIG_USB) += usb/ |
| 109 | obj-$(CONFIG_USB_SUPPORT) += usb/ |
| 110 | obj-$(CONFIG_PCI) += usb/ |
| 111 | obj-$(CONFIG_USB_GADGET) += usb/ |
| 112 | obj-$(CONFIG_OF) += usb/ |
| 113 | obj-$(CONFIG_SERIO) += input/serio/ |
| 114 | obj-$(CONFIG_GAMEPORT) += input/gameport/ |
| 115 | obj-$(CONFIG_INPUT) += input/ |
| 116 | obj-$(CONFIG_RTC_LIB) += rtc/ |
| 117 | obj-y += i2c/ media/ |
| 118 | obj-$(CONFIG_PPS) += pps/ |
| 119 | obj-y += ptp/ |
| 120 | obj-$(CONFIG_W1) += w1/ |
| 121 | obj-y += power/ |
| 122 | obj-$(CONFIG_HWMON) += hwmon/ |
| 123 | obj-$(CONFIG_THERMAL) += thermal/ |
| 124 | obj-$(CONFIG_WATCHDOG) += watchdog/ |
| 125 | obj-$(CONFIG_MD) += md/ |
| 126 | obj-$(CONFIG_BT) += bluetooth/ |
| 127 | obj-$(CONFIG_ACCESSIBILITY) += accessibility/ |
| 128 | obj-$(CONFIG_ISDN) += isdn/ |
| 129 | obj-$(CONFIG_EDAC) += edac/ |
| 130 | obj-$(CONFIG_EISA) += eisa/ |
| 131 | obj-$(CONFIG_PM_OPP) += opp/ |
| 132 | obj-$(CONFIG_CPU_FREQ) += cpufreq/ |
| 133 | obj-$(CONFIG_CPU_IDLE) += cpuidle/ |
| 134 | obj-y += mmc/ |
| 135 | obj-$(CONFIG_MEMSTICK) += memstick/ |
| 136 | obj-$(CONFIG_NEW_LEDS) += leds/ |
| 137 | obj-$(CONFIG_INFINIBAND) += infiniband/ |
| 138 | obj-$(CONFIG_SGI_SN) += sn/ |
| 139 | obj-y += firmware/ |
| 140 | obj-$(CONFIG_CRYPTO) += crypto/ |
| 141 | obj-$(CONFIG_SUPERH) += sh/ |
| 142 | ifndef CONFIG_ARCH_USES_GETTIMEOFFSET |
| 143 | obj-y += clocksource/ |
| 144 | endif |
| 145 | obj-$(CONFIG_DCA) += dca/ |
| 146 | obj-$(CONFIG_HID) += hid/ |
| 147 | obj-$(CONFIG_PPC_PS3) += ps3/ |
| 148 | obj-$(CONFIG_OF) += of/ |
| 149 | obj-$(CONFIG_SSB) += ssb/ |
| 150 | obj-$(CONFIG_BCMA) += bcma/ |
| 151 | obj-$(CONFIG_VHOST_RING) += vhost/ |
| 152 | obj-$(CONFIG_VHOST) += vhost/ |
| 153 | obj-$(CONFIG_VLYNQ) += vlynq/ |
| 154 | obj-$(CONFIG_STAGING) += staging/ |
| 155 | obj-y += platform/ |
| 156 | |
| 157 | obj-$(CONFIG_MAILBOX) += mailbox/ |
| 158 | obj-$(CONFIG_HWSPINLOCK) += hwspinlock/ |
| 159 | obj-$(CONFIG_REMOTEPROC) += remoteproc/ |
| 160 | obj-$(CONFIG_RPMSG) += rpmsg/ |
| 161 | obj-$(CONFIG_SOUNDWIRE) += soundwire/ |
| 162 | |
| 163 | obj-$(CONFIG_ENERGY_MODEL) += energy_model/ |
| 164 | |
| 165 | # Virtualization drivers |
| 166 | obj-$(CONFIG_VIRT_DRIVERS) += virt/ |
| 167 | obj-$(CONFIG_HYPERV) += hv/ |
| 168 | |
| 169 | obj-$(CONFIG_PM_DEVFREQ) += devfreq/ |
| 170 | obj-$(CONFIG_EXTCON) += extcon/ |
| 171 | obj-$(CONFIG_IIO) += iio/ |
| 172 | obj-$(CONFIG_VME_BUS) += vme/ |
| 173 | obj-$(CONFIG_IPACK_BUS) += ipack/ |
| 174 | obj-$(CONFIG_NTB) += ntb/ |
| 175 | obj-$(CONFIG_FMC) += fmc/ |
| 176 | obj-$(CONFIG_POWERCAP) += powercap/ |
| 177 | obj-$(CONFIG_MCB) += mcb/ |
| 178 | obj-$(CONFIG_PERF_EVENTS) += perf/ |
| 179 | obj-$(CONFIG_RAS) += ras/ |
| 180 | obj-$(CONFIG_THUNDERBOLT) += thunderbolt/ |
| 181 | obj-$(CONFIG_CORESIGHT) += hwtracing/coresight/ |
| 182 | obj-y += hwtracing/intel_th/ |
| 183 | obj-$(CONFIG_STM) += hwtracing/stm/ |
| 184 | obj-$(CONFIG_ANDROID) += android/ |
| 185 | obj-$(CONFIG_NVMEM) += nvmem/ |
| 186 | obj-$(CONFIG_FPGA) += fpga/ |
| 187 | obj-$(CONFIG_FSI) += fsi/ |
| 188 | obj-$(CONFIG_TEE) += tee/ |
| 189 | obj-$(CONFIG_MULTIPLEXER) += mux/ |
| 190 | obj-$(CONFIG_UNISYS_VISORBUS) += visorbus/ |
| 191 | obj-$(CONFIG_SIOX) += siox/ |
| 192 | obj-$(CONFIG_GNSS) += gnss/ |
| 193 | obj-$(CONFIG_INTERCONNECT) += interconnect/ |